In this episode, I share two of my favorite cups, the two of them reversed. In the first cup, I show how to create a magnetic, reusable, easy-to-recycle bottle when you don’t want to clean it. In the second, I show how to create a water bottle that is the least complicated water bottle you can buy.
I think the easiest way to create a magnetic bottle is to use a magnet. It’s basically just a magnetic metal that sticks to anything. But for a drink, you need a magnet to actually make the bottle spin. To make this bottle spin you would need a magnet, a metal foil, and a bit of fabric. So how do you create a magnet? You wrap a piece of iron or copper foil around a magnet and stick it into a piece of steel.
If you have a piece of steel that is strong enough you could just slide a magnet under it. But this is not an easy task because the surface of a magnet is not smooth and the metal foil is rough. But if you were to try this out, you would find it works. First, you need to wrap a piece of iron or copper foil around the magnet. Next, you would want to stick the magnet into the metal foil.
If you wrap one piece of steel around the magnet and then the second piece of steel, you will need to cut a slit in the metal foil to let the magnets slide through, so the magnet won’t slip out.
The magnet that the two steel pieces are wrapped around will have an “X” cut in it. You can use a pair of needle-nosed pliers or a pair of scissors to cut the slit in the foil. The magnet is then easy to slide through the slit. If any part of the magnet falls into the metal foil it will become stuck.
If you have a magnet that’s got a magnetic field around it, you can make a pin with a hole in the middle. All you have to do is slide the pin over the magnet, so when the hole is in the middle, the magnet won’t slide through. You can use a pair of needle-nosed pliers to cut through the hole in the middle.
For the next time you’re at a party and want to cut a hole into a piece of foil, you can use a pair of needle-nosed pliers to cut the hole in the foil. The magnet is then easy to slide through the slit. If any part of the magnet falls into the metal foil it will become stuck.
The next time youre at a party and want to cut a hole into a piece of foil, you can use a pair of needle-nosed pliers to cut the hole in the foil. The magnet is then easy to slide through the slit. If any part of the magnet falls into the metal foil it will become stuck.
The “cups-reversed” piece of foil that I mentioned in the previous paragraph is also called a “stair-step sheet.” It is a piece of foil that has a hole cut into one side. Once you put the magnet through it it can be pulled up and down on the other side. You can then slide the magnet back through the hole in the first side and slide it up the other side.
The first step in making a magnet with a hole cut into one side is to make sure that the hole is large enough. If you don’t have a drill you can make a hole with a pencil. If you do a drill you’ll need to use a small bit of sandpaper to make a larger hole. The second step is to take the magnetic material and put it through a metal rod or piece of copper.